Königin machines are made to run season after season, and when a seal hardens or a drive part wears, Königin spare parts put the extractor or tank back into service without replacing the whole unit. The silicone honey gate gasket, 60mm outside and 45mm inside diameter, is the part to keep on the shelf, because a tired gasket is where a Königin extractor or tank outlet starts to weep.
The stainless honey gate adaptor is for plumbing rather than bottling. It suits a Königin honey gate flange of 55mm inside and 75mm outside diameter and converts it to a 1.5 inch male BSP thread for connecting threaded fittings. On the drive side, the replacement pulley is made for the Königin 250W single-phase electric motor: a cast iron, single-groove SPZ V-pulley, 100mm across, mounted on a 1210 taperlock bush for an 11mm shaft and held by two grub screws. Before ordering Königin spare parts for a drive, read the rating on the motor plate and measure the shaft, since a pulley of the right diameter with the wrong bore will not go on.
For a new outlet on a bucket or tank, see our honey gates and taps. Parts for manual hobby spinners are under honey extractor spares, and complete machines are with our Königin honey extractors. The team in Perth and Sydney can help identify a part.
SS Königin Honey Gate adaptor
Honey gate 55 ID Flange 75 OD to Male 1.5 inch BSP
Replacement pulley for Konigin 250W 1PH Electric motor
Features:
- Cast Iron Construction
- Taperlock with grub screws (2)
Includes:
- SPZ V-Pulley 1 groove Cast Iron OD 100mm
- 1210 Taperlock Bush for shaft 11mm diameter